Filter
Top Products
TOOLS YOU WILL NEED
CHECK BOX FOR THESE CONTENTS
PLEASE READ COMPLETELY BEFORE YOU BEGIN ASSEMBLY
Cascadia Arbor
ASSEMBLY INSTRUCTIONS
11
PRELIMINARIES
Trellis Caps (7)
Headers (2)
Braces (4)
Lattice Side Panels (2)
1
2
3
• Phillips screwdriver (electric driver recommended)
•
Two bags of concrete mix (60#) to anchor the arbor
Your arbor has been submerged in high quality acrylic primer. An attractive finish coat of quality paint is recom-
mended.
If you decide to repaint your arbor, we recommend that you do so before assembly, it makes the job easier. Be careful
not to cover up guide marks on top of headers.
ARBOR PAINTING:
HANDY TO HAVE
• Tape measure
•
Carpenters Square
• Stool or short ladder
WORK AREA
Select an area close to where the arbor will be finally placed. While the assembled unit is not very heavy, it is awkward
to move far and requires two people to do so easily.
The assembly area should be relatively flat and open, at least 8’x6’. A lawn, driveway or wide path will be satisfactory.
It is a good idea to lay out the arbor box on your work surface to protect the arbor from nicks and scratches.
445.35.05
HARDWARE
4
- 1 5/8” Wood screws (26)
- 2 1/2” Wood screws (4)
- Wood block marked “spacer” (1)
- Anchoring kit.
1
2
3
4