Filter
Top Products
4
Pay attention to all warning labels and instructions printed on the exterior
of your ANTARI Liquid Control Unit
♦ Maximum pressure of the pump inside the machine is 7 BAR.
♦ Maximum fog output is 20,000 cubic feet/minute.
♦ Visibility during operation is reduced.
♦ Use only the high-quality, water-based fog liquid that your dealer
recommends. Other fog liquids may cause clogging or “spitting”.
♦ Operating this unit without liquid will cause damage to the pump.
♦ If your ANTARI Liquid Control Unit fails to work properly, discontinue
use immediately, pack the unit securely (preferably in the original
packing material), and return it to your ANTARI dealer for service.
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to
operate the system has arrived intact. Refer to the “Features” section for
information on what items are included with your model. If any
equipment is missing contact your ANTARI dealer immediately.
Before beginning initial setup of your ANTARI Liquid Control Unit, make
sure that there is no evident damage caused by transportation. In the
event that the unit’s housing or cable is damaged, do not plug it in and
do not attempt to use it until after contacting your ANTARI dealer for
assistance.
Setup
♦ See connection diagram