Filter
Top Products
6
Caution: Never handle your Andis trimmer while you are operating a water faucet,
and never hold your clipper under a water faucet or in water. There is danger of
electrical shock and damage to your clipper. Andis Company will not be
responsible in case of injury due to this carelessness.
If you are not familiar with this procedure, please return trimmer to your
supplier or an Andis Authorized Service Station for blade replacement and
adjustment.
To remove blade set from your trimmer, unplug your trimmer from the
electrical outlet. Turn the trimmer upside down so the teeth of blades are
facing down. You may wish to set the trimmer on a flat surface while
performing these operations. Unscrew the two blade screws (Figure F).
Remove blade set from trimmer. To install your new trimmer blade set, align
hole in upper blade (smaller of the two blades) and center over nylon roller
(ball) of the trimmer’s tension spring (Figure G). Align screw holes of lower
blade (larger of the two blades) to armature screw holes. While holding blade
in place, replace blade screws; do not tighten down completely. Turn trimmer
over and align the blade set parallel to the trimmer’s upper housing.
IMPORTANT: Check blade alignment, making sure the teeth of the upper
blade rest slightly below the upper edge of teeth on lower blade (Figure H).
Failure to check the position of blade may cause cutting or scratching of your
client’s skin when trimming. Tighten down blade screws firmly. If after
turning on the trimmer you notice the hair guard is hitting the upper blade
(Figure I) loosen hair guard screws slightly and adjust hair guard away from
the upper blade approximately 1/32". Tighten down hair guard screws.
FACTORY REPAIR SERVICE
When the blades of your Andis trimmer become dull after repeated use,
it is advised to purchase a new set of blades available through your Andis
Supplier or through an Andis Authorized Service Station. If you wish your
trimmer to be serviced as well, it should be carefully packed and mailed
either Parcel Post Insured, or U.P.S. to any Andis Authorized Service Station.
To find an Andis Authorized Service Station near you log on to www.andis.
com or contact our customer service department: 1-800-558-9441 (U.S.) or
1-800-335-4093 (Canada).