Filter
Top Products
5
OPERATING INSTRUCTIONS
Please read the following instructions before using your new Andis trimmer.
Give it the care that a fine precision built instrument deserves and it will give
you years of service. Before starting trimmer remove blade guard (some
models may not have a blade guard). Plug cord into electrical outlet, operate
at 120 volt, 60 cycle AC electrical current or as noted on the unit. To start
trimmer move switch button to on position, to stop, move switch button back
to original position. After using your Andis trimmer, rewrap cord and store in
a safe place.
USER MAINTENANCE
The internal mechanism of your trimmer has been permanently lubricated at
the factory. Other than the recommended maintenance described in this
manual, no other maintenance should be performed, except by Andis
Company or an Andis Authorized Service Station. To find an Andis Authorized
Service Station near you log on to www.andis.com or contact our customer
service department: 1-800-558-9441 (U.S.) or 1-800-335-4093 (Canada).
CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES
Blades should be oiled before, during, and after each use. If your trimmer
blades leave streaks or slows down, it’s a sure sign blades need oil. The
trimmer should be held in a position shown (Figure D) to prevent oil from
getting into motor. Place a few drops of Andis Clipper Oil on the front and
side of the cutter blades (Figure E). Wipe excess oil off blades with a soft dry
cloth. Spray lubricants contain insufficient oil for good lubrication, but are an
excellent trimmer coolant. Always replace broken or nicked blades to prevent
injury. You can clean the excess hair from your blades by using a small brush
or worn out tooth brush. To clean the blades we suggest to immerse the
blades only into a shallow pan of Andis Clipper Oil, while the trimmer is
running. Any excess hair and dirt that has accumulated between the blades
should come out. After cleaning, turn your trimmer off and dry blades with a
dry cloth and start clipping again.
REPLACEMENT (REMOVAL) OF BLADE SET
NOTE: If you are familiar with replacing and adjusting Andis GO and GTO
trimmer blades, please read the following blade replacement instructions.