Filter
Top Products
7
OPERATING INSTRUCTIONS
Please read the following instructions before using your new Andis Clipper. Give it the care that a
fine precision built instrument deserves and it will give you years of service.
REMOVING BLADE SET
To remove blade set, first make sure your clipper motor is switched “OFF”. Push blade release
mechanism under blade hinge (Diagram G). While holding down the blade release mechanism, push
down on blade, then gently pull the blade forward (Diagram H), and slide it off the blade hinge. If
your blade hinge should snap closed and is flush with the clipper, use a small standard screwdriver
to pry the tongue of the hinge out (Diagram I).
NOTE: Hair may accumulate in the front cavity of the housing under the blade. If this happens, you
can clean out the hair by brushing out the cavity with a small brush or an old toothbrush while the
blade is off the clipper (See Diagram K for location of cavity being referenced).
REPLACING OR CHANGING BLADE SET
To replace or change your blade set, slide the blade bracket onto the hinge of the clipper (Diagram J)
and with the clipper turned “ON”, push the blade towards the clipper to lock into position.
USER MAINTENANCE
The internal mechanism of your motor clipper has been permanently lubricated by the factory. Other
than the recommended maintenance described in this manual, no other maintenance should be
performed, except by Andis Company, or an Andis Authorized Service Station. To find an Andis
Authorized Service Station near you log on to www.andis.com or contact our customer service
department: 1-800-558-9441 (U.S.) or 1-800-335-4093 (Canada).
Diagram G
Diagram H Diagram I
Diagram KDiagram J