Filter
Top Products
2
5
6
OPERATION
5
CONNECT FLEXIBLE HOSE TO DIVERTER
7
MAINTENANCE
9-3/4"
UP AND DOWN
TRAVEL OF UNIT
Removing spray for cleaning or changing spray location
Figure 1.
Unscrew the TRIM RING (2) on the outside of the SPRAY HEADS (1)
by twisting 1/8th of a turn counter-clockwise.
Remove the O-RING (4) and NOZZLE (3).
Nozzle (3) can be cleaned using soft bristled brush.
Replace O-RING (4) and NOZZLE (3) and lock the TRIM (2) into place by
twisting it clockwise until it clicks.
Adjusting tension of SPRAY UNIT on vertical rails.
Shower system comes with two FRICTION CLIPS (5)
installed.
Move SPRAY UNIT (6) up and down along vertical
rails. FRICTION CLIP (5) holds the SPRAY UNIT (6)
at desired location.
(Figure 2)
If SPRAY UNIT (6) has too much tension on
vertical rails, then remove one FRICTION CLIP (5) or
reposition the CLIPS (5) closer to the center of the
unit. (Note: Tension on vertical rails will reduce when
shower system is moistened from shower application.)
SPRAY UNIT (1) can be adjusted up
and down by sliding unit along the
rails. (See Maintenance section for
steps to adjust the tension of SPRAY
UNIT (1) on the rails.)
Shower function can be diverted by
rotating DIVERTER ARM (2) clockwise
for flow out of SPRAYS (3) and counter-
clockwise for flow out of
SHOWER HEAD (4).
SHOWER HEAD SPRAY (5) can be
adjusted by rotating outer ring on
the faceplate.
(Figure 3)
To replace FRICTION CLIP (5), insert
groove of FRICTION CLIP (5) onto inside edge of
SPRAY UNIT (6). Rotate other end down and press
until the FRICTION CLIP (5) snaps into position onto
tab of SPRAY BODY (7).
2
1
5
5
5
7
2
1
3
4
4 3
COUNTER-CLOCKWISE
TO REMOVE
CLOCKWISE
TO INSTALL
31
Thread the HOSE COUPLING (1) onto DIVERTER
NIPPLE (2) and hand tighten clockwise. Note: Moulded
end of HOSE COUPLING (1) creates watertight seal with
with thread of DIVERTER NIPPLE (2), so seal washer is
not required.
Make sure HOSE (3) is not kinked or twisted.
GROOVE
TAB
VERTICAL RAILS
6
Figure 1
Figure 2
Figure 3
6
8
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT
CLEAN WITH CLEAR WATER. DRY
WITH A SOFT COTTON FLANNEL
CLOTH.
DO NOT: CLEAN THE PRODUCT WITH
SOAPS, ACID, POLISH, ABRASIVES,
HARSH CLEANERS, OR A CLOTH
WITH A COARSE SURFACE.
HOT LINE FOR HELP
For toll-free information and answers to your questions, call:
1 (800) 442-1902
Weekdays 8:00 a.m. to 7:00 p.m. Eastern Time
IN CANADA 1-800-387-0369 (TORONTO 1-905-306-1093)
Product names listed herein are trademarks of American Standard Inc.
©American Standard Inc. 2004
M968416 REV 1.1