Filter
Top Products
14
753737-100 Rev. E
OPERATION:
NOTE: Each whirlpool is shipped from the factory with an air actuator on/off switch and pump with attached
power supply cord. OPERATING THE SYSTEM WITHOUT WATER (DRY RUNNING) WILL CAUSE PUMP
DAMAGE AND VOID THE WARRANTY. Always fill the whirlpool before operating the pump. The air switch is
mounted either on the deck or side wall of the tub.
Fill the Whirlpool: Water level must be at least one inch (25mm) above the highest jet for proper operation.
(See diagram below.)
Do not fill whirlpool more than 2/3 full prior to the user completely immersing themselves into unit.
Start Whirlpool: Push on center of button. Button will depress and whirlpool will start.
Stop Whirlpool: Depress and release button and whirlpool will stop.
OUTLET MUST BE
GFCI PROTECTED
(all heaters require separate GFCI)
AIR ACTUATOR SWITCH
(location varies with model)
AIR TUBING
WATER LEVEL
6060L/V includes factory installed heater
Air Volume Control Adjustments: Water turbulence is determined by the amount of air mixed with the
water. Rotate the air volume control counterclockwise for more turbulence--clockwise for less.
SAFE-T-HEATER
REMOVABLE BLANK
1.
2.
3.
4.
Air Volume Control Adjustments:
MORE AIR LESS AIR
*
*