Filter
Top Products
TYPICAL CORNER INSTALLATION
UNLESS AN ACCESS OPENING OF AT LEAST
12" X 24" (305 X 610 mm) IS PROVIDED,
WARRANTY SERVICE WILL NOT BE PERFORMED.
59-1/2
(1511 mm)
CUTOUT
59-1/2
(1511 mm)
CUTOUT
30
(762 mm)
17-1/2
(445 mm)
12
(305 mm)
24
(610 mm)
LEFT-HAND DRAIN
ACCESS PANEL
RIGHT-HAND DRAIN
ACCESS PANEL
LEVELING
STRINGER
FRAMING AND INSTALLATION
THE VARIETY OF INSTALLATIONS POSSIBLE FOR THIS BATH MAY REQUIRE FRAMING PROCEDURES OTHER THAN THOSE
SHOWN.
LOCATE STUDS AS REQUIRED. INSURE ROUGH DIMENSIONS ARE PROPER, PLUMB AND SQUARE. FOR WHIRLPOOLS,
PROVISION MUST BE MADE IN ALL INSTALLATIONS FOR AN ACCESS OPENING FOR SERVICING PUMP AND
CONTROLS.
THE FOLLOWING PROCEDURE MUST BE USED FOR ALL INSTALLATIONS: STRINGER OR PIER HEIGHT SHOULD BE AS
INDICATED. THIS BATH MUST BE SUPPORTED ALONG IT'S ENTIRE BOTTOM. WE RECOMMEND THE USE OF
MORTAR AS A BEDDING MATERIAL (SAND IS NOT RECOMMENDED). APPLY ENOUGH BEDDING TO SUPPORT THE
COMPLETE BOTTOM OF THE BATH. AFTER THE BEDDING HAS BEEN POURED, AND BEFORE IT SETS, POSITION
WHIRLPOOL OR BATH WITHIN INSTALLATION UNTIL THE RIM IS LEVELED AGAINST THE LEVELING STRINGERS (SEE
"TYPICAL CORNER INSTALLATION") SHOWN BELOW. THE RIM OF THE BATH MUST NOT SUPPORT WEIGHT. ALLOW
THE BEDDING MATERIAL TO COMPLETELY HARDEN BEFORE APPLYING WEIGHT TO THE RIM OR BOTTOM OF THE
BATH. ANY FINISH MATERIAL SUCH AS WALL BOARD OR TILE MUST BE SELF-SUPPORTING IF IT CONTACTS THE
DECK OF THE BATH.
753451-100 Rev. A (2)
SUGGESTED INSTALLATION
METHODS
LEVELING SURFACE
WATERPROOF
SEALANT
SUNKEN OR ISLAND
INSTALLATION
RECESSED INSTALLATION
BATH
WATERPROOF
SEALANT
TILE
TILE
BEAD
STRIP
LEVELING
STRINGER
BATH
*
* NOTE: If the optional apron (PN 0730.121) is to be used with this tub, the stringer
height must be referenced from the finished floor.