Filter
Top Products
5
1)
Options / model variants
Original instructions
NEPTUNE 5 FA
2.2 Operating elements
See fold-out page at front of these
operating instructions.
1 Spray lance
2 Spray lance storage
3 Control panel
4 Crank handle for
High pressure hose reel
(Neptune ..X)
1)
Cord reel (Neptune ..X2)
1)
5 Fuel level gauge
6 Tank fi ller for fuel
7 Receptacle for service
crane and lifting ring
1)
8 Top cover release
9 Service door release
10 Crank handle for
High pressure hose reel
(Neptune ..X2)
1)
11 High pressure hose connec-
tion for machines without
hose reel
12 Main switch ON/OFF - cold
water/hot water
13 Display (Temperature or
Codes)
14 Temperature control
15 Low fuel indicator
16 Low Nilfi sk-ALTO AntiStone
(Anti-Scale) indicator
17 Service interval due/expired
18 Pump oil low
19 Detergent metering knob
20 Pressure gauge
21 Power ON
22 Castor with parking brake
23 Water supply connection
24 Tank fi ller for anti-freeze
25 Tank fi ller for Nilfi sk-ALTO
Anti-Scale
26 Canister for detergent B
1)
27 High pressure hose reel
(Neptune ..X)
1)
28 Power cord reel
(Neptune ..X2)
1)
29 Tank fi ller for detergent A
30 Grip for top cover
3 Before starting the cleaner
3.1 Transport and assembly
chine by hand from the pallet.
Due to the weight this work
should be done by at least
three persons.
CAUTION!
Do not hold the plastic tank to lift
the machine as it could become
detached from the frame.
The best places to hold the ma-
chine are
– on the handle
– on the frame between the front
wheels and the guide rollers.
Every fuel-burning appliance, such
as pressure washers, depends
upon a proper mix of fuel and air
(by weight) for proper combustion.
Therefore some adjustment of the
air supply to the burner may be nec-
essary to take account of altitude
and the resulting air pressure. This
is true whether your fuel is ‘Natural
gas’, Propane or Diesel.
Your Nilfi sk-ALTO hot water pres-
sure washer was thoroughly tested
and adjusted for optimum perform-
ance before it left our factory. The
factory is located at approximately
120m (390 ft) above sea level, and
the combustion settings are optimal
for that elevation.
If your location is higher than
1200m (3900 ft) above sea level,
your burner may require re-ad-
justment for proper performance
and best fuel economy. Contact
your Dealer or Nilfi sk-ALTO for
assistance.
3.2 Set the brake
1. Before using the cleaner for
the fi rst time, check it careful-
ly for any faults or damage.
2. Run the machine only when
it is in perfect working condi-
tion.
3. Set the brake.
4. The slope on which the high
pressure cleaner is placed
must not exceed more than
10
0
in any direction.
1. The safest way to lift the ma-
chine is to use a fork-lift truck
The arrows in the illustration
indicate the best places to po-
sition the fork.
2. It is also possible to lift the ma-