Filter
Top Products
ALPS-Spas 4400 Steve Reynolds Blvd. Norcross, Georgia 30093
770-381-2022 Fax: 770-925-1900 www.ALPS-spas.com
Preset fi lter Cycles:
Your spa is programmed from the factory to fi lter twice a day for two hours each time.
During this time pump one will come on in low speed automatically. The spa is fully
operational at this time and safe to use. If for any reason you would like to change the
fi lter settings please refer to the EL/GL Series laminated card.
Setting the Time:
Refer to the EL/GL Series laminated card.
Diagnostic Messages:
If you see a diagnostic message appear on the top side control the spa has indicated
a problem. Refer to the EL/GL series card under diagnostic messages. Follow the
instructions, if it has a problem you can not fi x please contact your dealer for service.
Invert:
Invert is a feature on the Balboa AL9000 or AE9000 control that reverses the LED
readout for better viewing from inside the spa. On a two pump system, the invert key is
located at the top right of the control. If you have a three pump system, touch the warm
button once, and then jet 3 to invert the screen. Repeat, then change the screen back.
**All spas are set-up for twenty minute therapeutic cycles. This means once your spa
runs for 20 minutes, it will automatically shut off. Do not be alarmed, your spa is not
broken. Hit your Jet icon to activate another 20 minute cycle. This feature is installed
for two reasons. One is to remind the owner that they have been in the hot tub for a full
therapeutic cycle, and the other is energy conservation.
NOTES
CONTROLS
page 05