Filter
Top Products
ALPS-Spas 4400 Steve Reynolds Blvd. Norcross, Georgia 30093
770-381-2022 Fax: 770-925-1900 www.ALPS-spas.com
Initial Start-up:
confi guration numbers). This priming mode will last up to four minutes and then begin
to preset fi lter cycles (--F) for two minutes. Once the diagnostics are complete the control
will display the current temperature and begin to heat in the standard mode. The spa will
maintain temperature in standard mode.
Temperature Adjustment: 80 F – 104 F (26 C – 40 C)
Once the spa is activated it will begin to heat to 100 F. To change the temperature, press
the warm and cool icons on the control. The control will display the current temperature,
to see the set temperature press the warm or cool button, after a few seconds the current
temperature will return to the display.
Jets/Pumps:
Depending on model, your spa will be equipped with either 2 or 3 pumps. The JET 1 icon
controls the main pump. This is a two speed pump. Touch JET 1 once for low speed, twice
for high speed and a third time to turn off. Notice that pump one will come on in low
speed during fi lter cycles. Jet 2 is also on a two speed pump, but it will not engage
during fi lter cycles unless you turn it on. If your spa is equipped with a third pump touch
JET 3 to engage. This pump runs only in high speed. Touch the JET 3 icon once to turn the
pump on and once again to turn it off.
Light
:
All spas are equipped with LED lighting systems. The standard lighting system consists of
a 9 bulb main light with several different colors. With this system touch the light icon once
to turn the light on and once to turn off. The colors are random so you may need to turn the
light on and off several times to fi nd your desired color. If you have purchased a spa with
the upgraded illuminated spa fountains or perimeter package there are 10 different color
settings. Listed below are the different settings:
1. Color-Wheel. This mode transitions the different colors
2. White
3. Aqua (Green and Blue)
4. Purple (Red and Blue)
5. Blue
6. Amber (Red and Blue)
7. Green
8. Red
9. Color Flash. This mode switches colors every few seconds.
10. Strobe. This mode fl ashes the LEDs on and off like a strobe light.
CONTROLS
NEW EL/GL 2000
BALBOA CONTROL
Quick Reference Card
page 04