Filter
Top Products
ASSEMBLY
SX15 01/09 Assembly Section 3-7
© 2009 Alamo Group Inc.
ASSEMBLY
FRONT AND REAR DEFLECTORS (Standard Equipment) CHAINGUARDS
( OPTIONAL EQUIPMENT)
CHAIN GUARDS: Front and Rear Chain Guards (Optional Equipment) are recommended for higher than
normal usage (100 hours or more per year) and will provide protection from thrown objects with careful
operation. Chain Guards must be maintained in good repair by replacing missing or worn sections or by
replacing completely when worn or damaged.
The Front Chain Guards (3,6,7)
should be attached by using 1/2"
X 1-1/4" bolts(9), Washers (10),
andNuts (11) as shown in
FIGURE Asm-R-0178.
FIGURE Asm-R-0179. Install each
Chain Guard (2,5) using three 1/2" x 1-1/
4" Bolts (3) on the rear center and four 1/
2" x 1-1/4" Bolts on the rear wing,
Locknuts (6) and Washers (4).
HYDRAULIC SYSTEM ASSEMBLY
1. This unit can be operated on any tractor which has at least two remote outlets.
IMPORTANT: Remote outlets connected to wings cylinders must have a float detent position on the control
lever. If not the tractor must be equipped with an external valve bank which has float detent positions.
2. If tractor has only two outlets, one must be used to control the center axle and the other to control both
wings by placing a tee in the hoses between the cylinders. NOTE: When both wing hydraulic cylinders
are operated by one valve spool, independent control of wings is not possible. When valve is actuated to
raise wings, there is no control over which wing will raise first. If independent control is required, tractor
must be equipped with an external three-spool valve bank.
3. If a three-spool valve bank is required, then assemble it on a mounting bracket and install on the tractor
fender at desired location. (See valve bank plumbing diagram for further details).