Filter
Top Products
ASSEMBLY
SX15 01/09 Assembly Section 3-4
© 2009 Alamo Group Inc.
ASSEMBLY
5. Install Main Driveline. Attach Driveline Yoke to Mower Divider Gearbox. Tighten Clamping Cone Yoke to
75 lb-ft torque.
6. Attach Slip Clutch end of Wing Driveline to shaft on Divider Gearbox . Insert clamp bolts or clamping cone
depending on driveline type and tighten securely (75 lb-ft torque).
Many of the equipment components are HEAVY (60 lbs or greater) and Special Lifting
Procedures are recommended. Use lifting assistance such as mechanical assistance, two
people, and proper lifting techniques when connecting or installing the driveshaft to reduce
the possibility of back injuries
7. Install Center Divider Gearbox Shield. Remove the top two bolts and lockwashers from the Center
Gearbox. Install the shield on the Center Divider Gearbox and replace with longer hardware.
8. Install opposite end of Wing Driveline to outer Gearbox input shaft. Secure yoke on shaft by tightening
taper pin to 75 ft/lbs. located on Driveline Clamp. NOTE: To facilitate removal of Clutches and Yokes
from splined shafts in the future, it would help to place a small amount of lubricating grease on the splines
before installation.