Filter
Top Products
64
ST15 (Archive Book) 01/04
© 2004 Alamo Group Inc.
DOUBLE CHAIN
CHAIN GUARDS
ST15 / ST10
1. Only Double Chain Guards are available.
2. 9 Link sections of Chains are used and are hung by the 5 th link
to form the double Chain Guard. (See illustration below)
3. The Cables are laced through the Bottom Link of the Chain and
then a Cable Clamp is placed at each end of the Cable. (See
illustration below).
4. Front Center Section is in 3 pieces, 1 center (19 Chains) and 2 outer
(16 Chains ea.)
5. The Front Wings are 2 pieces (29 Chains ea.) on each wing, same
LH or RH. There are two Chain Sections that bolt to a lug on the outer
side of each wing.
6. The Rear Center is in 2 pieces (24 Chains ea.)which are both the
same LH or RH Center.
7. The Rear Wings use 3 pieces, The center and inner Wing piece are
the same (19 Chains ea.), the outer for the wings is different (18
Chains)
8. The Chains are held in with a steel rod that is welded to the chain
guard bracket. to change or install chain sections these rods should
be replaced and rewelded.
Mower
Deck
Chain Guard
Bracket
Retaining Bolt
9 Link Chain
Section
Retaining Rod
(Welded to
Bracket)
9 Link Chain Section
is hung by inserting
the 5 th. Link