Filter
Top Products
OPERATION
PA92 04/09 Operation Section 4-29
© 2009 Alamo Group Inc.
OPERATION
Cutting Sequence
Operator preference will ultimately decide on the order of cutting. Where it is difficult to determine the original
hedge line because of overgrowth a recommended method is to start by siding up the hedge first, if necessary
making more than one pass.
A second cut should then be taken at an incline along the hedge top and again if there is prolific growth it may
be necessary to make more than one pass until the hedge is reduced to the height and contour required.
Finally, finish with a ground cut. The roller should be lowered for this. This ground cut defines the base line of
the hedge, severs shrubs and debris that encroach out from the bottom, and further mulches the toppings that
have fallen.