Filter
Top Products
ASSEMBLY
GR60/72 02/07 Assembly Section 3-5
© 2007 Alamo Group Inc.
ASSEMBLY
Stabilizer Bars or Sway Chains must be installed and adjusted tightly. Without these bars or
chains, serious damage to the Driveline can occur, and broken parts could cause bodily
injury to the operator or bystanders. Stabilizer Bars or Sway Chains are available at most
tractor dealerships.
4. Raise the Cutter to check clearance between the Driveline and Cutter Deck. Set the lift stop on the tractor
to ascertain that the Driveline does not strike the deck.
Front Deflectors (Standard Equipment) and Chain Guards(Optional
Equipment at Extra Cost)
Deflectors: Front and Rear Deflectors (Standard Equipment) are recommended for the average user and will
provide protection from thrown objects with proper operation under normal conditions. Deflectors must be
maintained in good repair or replaced after no more than two inches of wear off lower edge.
Front Rubber Fabric Deflectors (Standard Equipment)
Front Deflector (Figure Asm-0003)
1. Attach the Front Bracket (1) to the front of the
mower with 1/2" x 3" Bolts (3), Flatwashers (9)
and Locknuts (4).
2. Attach the Front Deflector (2) to the Bracket
with 3/8" x 1-1/2" Bolts (5), Woodwashers (8),
Flatwashers (6), and Locknuts (7).
Front and Rear rubber-fabric Deflectors are Standard Equipment and Front and
Rear Chain Guards are optional . One type of guard must be installed (and
maintained in good repair) except for agricultural purposes only in areas where
persons, vehicles, livestock, or other property will not be endangered by thrown
objects and where such safety equipment would prevent the mower's reasonable
performance of its assigned agricultural task. Assy01-Shielding