Filter
Top Products
SAFETY
GR60/72 02/07 Safety Section 1-7
© 2007 Alamo Group Inc.
SAFETY
There are obvious and hidden potential hazards in the operation of this
Mower. REMEMBER! This machine is often operated in heavy brush
and in heavy weeds. The Blades of this Mower can throw objects if shields are not
properly installed and maintained. Serious injury or even death may occur unless care is
taken to insure the safety of the operator, bystanders, or passersby in the area. Do not
operate this machine with anyone in the immediate area. Stop mowing if anyone is within
100 yards of mower.
(SGM-2)
All Safety Shields, Guards and Safety devices including (but not
limited to) - the Deflectors, Chain Guards, Steel Guards, Gearbox
Shields, PTO integral shields, and Retractable Door Shields should be used and
maintained in good working condition. All safety devices should be inspected
carefully at least daily for missing or broken components. Missing, broken, or worn
items must be replaced at once to reduce the possibility of injury or death from thrown
objects, entanglement, or blade contact.
(SGM-3)
The rotating parts of this machine have been designed and tested for rugged use.
However, the blades could fail upon impact with heavy, solid objects such as metal guard
rails and concrete structures. Such impact could cause the broken objects to be thrown outward at very high
velocities. To reduce the possibility of property damage, serious injury, or even death, never allow the cutting
blades to contact such obstacles.
(SGM-4)
E
x
t
reme care s
h
ou
ld
b
e
t
a
k
en w
h
en opera
ti
ng near
l
oose o
bj
ec
t
s suc
h
as gravel, rocks, wire, and other debris. Inspect the area before
mowing. Foreign objects should be removed from the site to prevent machine damage
and/or bodily injury or even death. Any objects that cannot be removed must be clearly
marked and carefully avoided by the operator. Stop mowing immediately if blades strike a
foreign object. Repair all damage and make certain rotor or blade carrier is balanced
before resuming mowing.
(SGM-5)
M
any var
i
e
d
o
bj
ects, suc
h
as w
i
re, ca
bl
e, rope, or c
h
a
i
ns, can
b
ecome entang
l
e
d
i
n t
h
e
operating parts of the mower head. These items could then swing outside the housing at
greater velocities than the blades. Such a situation is extremely hazardous and could result in serious injury
or even death. Inspect the cutting area for such objects before mowing. Remove any like object from the site.
Never allow the cutting blades to contact such items.
(SGM-6)
M
ow at t
h
e spee
d
t
h
at you can sa
f
e
l
y operate an
d
contro
l
t
h
e tractor an
d
mower.
S
a
f
e
mowing speed depends on terrain condition and grass type, density, and height of cut.
Normal ground speed range is from 2 to 5 mph. Use slow mowing speeds when operating on or near steep
slopes, ditches, drop-offs, overhead obstructions, power lines, or when debris and foreign objects are to be
avoided.
(SGM-7)