Filter
Top Products
OPERATION
FX17/FX21 02/11 Operation Section 4-18
© 2011 Alamo Group Inc.
OPERATION
• Ensure rubber deflectors are in position and not
damaged. Replace worn, broken, and missing
sections immediately.
• Ensure the rollers are in good condition and
rotate freely.
• Ensure the driveline integral shield is in good
condition and rotate freely.
• Inspect that all bolts and screws are in position
and are properly torqued. OPS-F- 0004
• Inspect the condition of the wings and rear
section drive belts.
• Ensure the slip clutch (rear mower section only)
is properly adjusted and the friction plates are
not frozen together. Reference the
Maintenance Section for proper slip clutch
maintenance.
• Ensure the slip clutch shield and drive belts
shields are in place and in good repair.
• Ensure the tractor PTO master shield is in
place, lowered and in good condition.
OPS-F- 0005
• Inspect oil level in gearbox and replenish if
needed. A low oil level is a warning sign that
the gearbox may be cracked or its seal is
damaged and needs to be replaced.
• Check the oil level in tank and replenish if
need. NOTE: Do not fill the tank with oil above
the level of the sight gauge. Over filling the
tank with oil after initial filling may result in oil
being discharged through the air filter on the
top of the hydraulic tank.
• Perform scheduled lubrication as specified in
the maintenance section. OPS-F- 0006