Agri-Fab 45-0405 Spreader User Manual


 
6
45_0382Fig8
1/8 x 3/4 in.
COTTER PIN (K)
FLOW
CONTROL
ROD
FLOW
CONTROL
LEVER
45_0382Fig11
POSITION 5
ADJUSTABLE
STOP
1/4 in. NYLOCK NUTS
FIGURE 11
FIGURE 8
12. Insert the end of the ow control rod through the slot in
the ow control mounting bracket and through the hole
in the ow control lever. Secure with a 1/8 in. x 3/4 in.
cotter pin. See gure 8.
45_0382Fig1045_0382Fig10
ADJUSTABLE
STOP
OFF
FIGURE 10
14. Adjust the position of the ow control mounting bracket
(gures 10 and 11):
a. Set the adjustable stop at “5.” Latch the ow control
lever against the stop. Verify that the closure plate
has opened about halfway. See gure 10.
b. If closure plate is not open halfway, adjust the position
of the ow control mounting bracket until the closure
plate is open about halfway at “5” and still closed when
the lever is in the “OFF” position. Carefully tighten
the 1/4 in. nylock nuts. Do not deform the slots in the
ow control mounting bracket.
c. Push the ow control lever to the “OFF” position
and ensure the closure plate closes completely.
See gure 11.
13. Install the adjustable stop on the slot in the top of
the ow control mounting bracket. Secure with the
1/4 in. x 3/4 in. carriage bolt, a nylon washer, a 1/4 in.
at washer and the nylon wing nut. See gure 9.
45_0382Fig945_0382Fig9
ADJUSTABLE
STOP (O)
1/4-20 WING NUT (M)
1/4-20 x 3/4 in.
CARRIAGE BOLT (D)
1/4 in. WASHER (F)
FIGURE 9