Agri-Fab 45-02932 Lawn Mower Accessory User Manual


 
4
ASSEMBLY INSTRUCTIONS
FIGURE 2
6. Assembleahitch arm tothe inside ofa frametube
underneaththetank.Usetwo5/16"x2"hexboltsand
5/16"nylocknutsasshowningure3.Do not tighten
yet.Repeatforotherside.
TOOLS REQUIRED FOR ASSEMBLY
(2) 1/2"Wrenches
(1) Screwdriver
(1) Pliers
FIGURE 1
1. Removeallitemsfromcartonandlayoutasshownon
pages 2 and 3.
2. Assembletheaxleclampsandfour5/16"SEMSnuts
tothefactoryinstalledboltsintheframetubes.Do not
tighten yet.Seegure1.
FIGURE 3
7. Fastentheendsofthehitcharmstogetherusingtwo
5/16"x1-1/4"hexboltsand5/16"nylocknuts.Do not
tighten yet. Seegure4.
8. Assemblethehitchbracketstothehitcharmsusing
two5/16"x2"hexboltsand5/16"nylocknuts.Position
eachboltbehindacrossboltinthehitcharms.Do not
tighten yet. Seegure4.
FIGURE 4
3/4" WASHER
SPACER
1/8" x 1-1/2"
COTTER PIN
3. Slidetheaxlethroughthetwoaxleclamps.Seegure
2.
4. Assemble a spacer, a 3/4" washer, a wheel (valve
stem facing out) and another 3/4" washer onto the
axle.Assembleacotterpinthroughtheendoftheaxle.
Repeatonotherend.Seegure2.
5. Tightenthefournutswhichfastentheaxleclampsto
theframetubes.Referbacktogure1.
5/16" x 2"
HEX BOLT
5/16" NYLOCK NUT
5/16" x 1-1/4"
HEX BOLT
5/16" NYLOCK NUT
9. Tighten all boltsstartingwiththeboltsingure3,then
theboltsingure4.
FACTORY
INSTALLED
BOLT
AXLE
CLAMP
5/16" SEMS NUT
5/16" x 2"
HEX BOLT
5/16" NYLOCK NUT
HITCH ARM
ENGLISH