Agri-Fab 45-0253 Chipper User Manual


  Open as PDF
of 28
 
8
FIGURE 4
8. To prevent accidental tipping during the following
assembly procedures, lower the cart to rest upside
down, with the wheel support facing up, as shown in
gure5.
9. Align the latch stand bracket so that the tab is at the
rear. Fasten the bracket to the rear set of holes at the
front of the cart using two 1/4" x 5/8" hex bolts, 1/4"
atwashersand1/4"nylocknuts.Usethe1/4"at
washers as shims between the bracket and the cart
bed. Makengertight.Seegure5.
FIGURE 6
11. Assemble a spacer tube onto each end of the axle as
showningure7.
12.Assemblea1"atwasher,awheel(valvestemfacing
out),andanother1"atwasherontotheaxleas
showningure7.Securethewheelwithacotterpin,
spreadingtheendssothatahubcapcantoverthe
pin.Assemblethehubcapbypressingitontotheat
washer. Repeat on other end of axle.
FIGURE 7
10. Position the rear tongue on the wheel support and the
latch stand bracket. Assemble the axle through the
wheel support and the tongue. Seegure6.
IMPORTANT: Make sure the tongue is securely locked
to the latch stand bracket by the latch lock lever.
7. Assemble the wheel support to the bottom of the cart
using eight 5/16" x 3/4" truss head bolts and 5/16"
nylocknutsasshowningure4.Headsofboltsgoon
the inside of cart. Tighten.
LATCH STAND
BRACKET
(Tab at rear)
1/4" x 5/8"
HEX BOLT
1/4" NYLOCK NUT
1/4" FLAT
WASHER
AXLE
TONGUE
(REAR)
LATCH
LOCK
LEVER
COTTER PIN
WHEEL
HUB CAP
1" FLAT
WASHER
1" FLAT
WASHER
AXLE
SPACER TUBE
FIGURE 5
5/16"
NYLOCK
NUT
WHEEL
SUPPORT
5/16" x 3/4"
TRUSS HEAD BOLT
 previous next