Agri-Fab 45-0253 Chipper User Manual


 
17
MAINTENANCE
Service Dates
Check for loose fasteners X
Check soft vinyl boot X
Check tire pressure X
Check engine oil level X
Lubricate X
Clean X X
Maintain engine per instructions below and in engine manual.
Before each use
After each use
Every season
Before storage
CUSTOMER RESPONSIBILITIES
• Readandfollowthemaintenancescheduleandthemaintenanceprocedureslistedinthissection.
MAINTENANCE SCHEDULE
Fill in dates as you
complete regular service.
BEFORE EACH USE
CHECK FOR LOOSE FASTENERS
1. Make a thorough visual check of the Chip-N- Vac
for any bolts and nuts which may have loosened.
Retighten any loose bolts and nuts.
CHECK VINYL BOOT
2. Check the soft vinyl boot (on front of hard top) for
wear. Replace if worn or damaged.
CHECK TIRE PRESSURE
3. Check tire pressure regularly. Recommended tire
pressure is 12-14 Lbs.
CHECK ENGINE OIL LEVEL
4. Check oil level before each use. Maintain engine oil as
instructed in the separate engine manual.
LUBRICATION
1. At the beginning of each season, lubricate the latch,
latch pivot bolt, and the axle where the hitch tongue
pivots, with a light machine oil.
2. At least once a season, grease or oil the wheel bear-
ings. Use automotive wheel bearing type grease or 20
weight oil.
WARNING: Always stop engine and
disconnect spark plug wire before
cleaning, lubricating or before performing
any repairs or maintenance.
ENGINE MAINTENANCE
1. Check oil level before each use. Maintain engine oil
as instructed in the separate engine manual.
2. Service air cleaner every 25 hours under normal
conditions. Clean every few hours under extremely
dusty conditions. Poor engine performance and
oodingusuallyindicatesthattheaircleanershould
be serviced. To service the air cleaner, refer to the
separate engine manual.
3. The spark plug should be cleaned and the gap
reset once a season. Spark plug replacement is
recommended at the start of each season. Check
the engine manual for correct plug type and gap
specications.
CLEANING
1. Make sure the cart, the side and front panels and
top are cleaned after each use. Grass clippings and
leaves left in the cart will mildew and cause damage if
not cleaned out.
2. Cleantheengine regularly with a cloth or brush.
Keepthecoolingnsontheenginehousingclean
to permit proper air circulation which is essential to
engine performance and life. Be sure to remove all dirt
anddebrisfrommuferarea.