Filter
Top Products
3
FIGURE 4
AXLE
SPACER
1/2" DIA.
FLAT WASHER
FIGURE 3
1/4" x 1-1/2"
HEX BOLT
1/4" NYLOCK
NUT
HITCH BRACE
HITCH
TUBE
HITCH BRACE
FIGURE 5
HUB CAP
INDENT
FIGURE 6
1/2" FLAT
WASHER
HUB CAP
END WITH NO
INDENT
Assemble the two hitch braces to the hitch tube using a 5.
1/4" x 1-1/2" hex bolt and a 1/4" nylock nut. See gure
3. Do not tighten at this time.
Tighten all loose hex nuts and bolts attached to hitch 6.
tube and hitch braces. Do not collapse tubes when
tightening.
Assemble a spacer and then a 1/2" at washer onto 7.
each end of the axle. See gure 4.
Place the drive wheel onto the end of the axle that has 8.
an indent. The long end of the hub goes to the inside.
See gure 5.
Place a hub cap onto the end of the axle. Using a small 9.
hammer, lightly tap the hub cap until it is snug against
the wheel. See gure 5.
Place the wheel (long end of hub rst) onto the end of 10.
the axle that has no indents. See gure 6.
Place a 1/2" at washer onto the axle and then lightly 11.
tap a hub cap onto the axle until it is snug against the
washer and wheel hub. See gure 6.