Filter
Top Products
6
17. Assemble the flow control arm to the flow control
mounting bracket using one 1/4" x 5/8" hex bolt and
one 1/4" lock nut. Do not over tighten. The flow
control arm must pivot freely. See figure 10.
18. Hook one end of extension spring through small hole
near bend in flow control rod and the other end through
hole in flow control mounting bracket. See figure 10.
FLOW
CONTROL
LINK
EXTENSION
SPRING
3/32"
COTTER
PIN
5/16" FLAT
WASHER
FLOW
CONTROL
ROD
FLOW CONTROL
MOUNTING BRACKET
19. Place a 5/16" flat washer over the end of flow
control rod, and insert end of rod through slot in
flow control mount bracket and through the hole
in flow control link. Secure with a 3/32" x 3/4"
cotter pin. See figure 11.
FIGURE 10
FIGURE 11
20. Hook free end of flow control rod through hole in slide
gate bracket located near bottom of hopper. See figure
12.
1/4" x 5/8"
HEX BOLT
1/4" HEX LOCK NUT
FLOW
CONTROL
LINK
EXTENSION
SPRING
FLOW
CONTROL
ROD
FLOW CONTROL
MOUNTING BRACKET
FLOW CONTROL ARM
HOPPER
SLIDE
GATE
BRACKET
FLOW
CONTROL
ROD
FIGURE 12
21. Assemble flow control mounting bracket and the handle
tube (short) to the handle tube (long) using two 1/4" x
1-1/2" hex bolts, two 5/16" flat washers and two 1/4"
lock nuts. See figure 13. DO NOT TIGHTEN AT THIS
TIME.
22. Place handle grip on each handle tube. See figure 13.
HANDLE GRIP
1/4" x 1-1/2"
HEX BOLTS
1/4"
LOCK
NUTS
HANDLE
TUBE
(SHORT)
HANDLE
TUBE
(LONG)
HANDLE GRIP
FLOW CONTROL
MOUNTING BRACKET
5/16"
FLAT
WASHERS
5/16"
FLAT
WASHERS
FIGURE 13