Filter
Top Products
FIGURE 14
20. Assemble the flow control gauge onto the flow
control mounting bracket as shown in figure 14.
Secure with nylon washer and hand knob.
FLOW CONTROL
MOUNTING BRACKET
PLASTIC KNOB
NYLON
WASHER
FLOW
CONTROL
GAUGE
OFF
FLOW
CONTROL
ARM
21. Move flow control arm to off position and slide flow
control mounting bracket toward hopper until clo-
sure plate (located in bottom of hopper) is com-
pletely closed. Tighten 1/4" hex lock nuts as-
sembled in step 19. See figure 14.
22. Pre-lubricate per lubrication section on page 9
before operating spreader.