Filter
Top Products
9
14. (Figure 18) Secure the rope to the top center of the
hopper bag frame.
15. (Figure 19) To assemble the hopper bag to the sweeper,
slide the ends of the bag arm tubes into the ends of the
sweeper's hitch tubes and secure with two 1/4" x 1-3/4"
clevis pins (R) and 3/32" hair cotter pins (O).
17
18
19
LOWER HOLE
3/32" HAIR
COTTER PIN (O)
3/8" x 3"
CLEVIS PIN (S)
BAG ARM TUBE
VINYL CAP
BAG ARM TUBE
1/4" x 1-3/4"
CLEVIS PIN (R)
3/32" HAIR
COTTER PIN (O)
ENGLISH
UPPER HOLE
LOWER HOLE
UPPER HOPPER SIDE TUBE
11. (Figure 16) Feel along the stitched fl ap on the hopper
bag to locate the lower hole in each upper hopper side
tube. Pierce a hole through both sides of the stitched
fl aps in alignment with the lower hole.
16
12. (Figure 17) Insert a 3/8" x 3" clevis pin (S) through
the lower hole in each upper hopper side tube. Next,
assemble a bag arm tube (pointing in direction shown)
onto each clevis pin and secure it with a 3/32" hair cotter
pin (O).
13. (Figure 17) Assemble a vinyl cap (V) onto the end of
each bag arm tube.