Agri-Fab 2468 Chipper User Manual


  Open as PDF
of 28
 
10
FIGURE 11
20.Placeasidepanelontopofthecartbedange,
inside the lip of the front panel. Fasten the side panel
to the front panel using three 1/4" x 5/8" hex bolts
and 1/4" nylock nuts. Fasten the side panel to the cart
bedangeusingtwo1/4"x5/8"hexbolts,1/4"at
washers and 1/4" nylock nuts. Tighten.Seegure11.
Repeat on other side.
FIGURE 12
23. Assemble a door latch at each end of the cross brace
using a 5/16" x 3/4" hex bolt, a nylon washer and a
5/16" nylock nut. Place the nylon washer between the
door latch and cross brace. Tighten so that latch is
snugbutwillstillrotate.Seegure13.
FIGURE 13
24. Install the poly hard top using fourteen 1/4" x 3/4"
hexboltsand1/4"atwashersontheoutsideand
fourteen1/4"atwashersand1/4"nylocknutsonthe
inside. Tighten.Seegure14.
FIGURE 14
1/4"x5/8"
HEX BOLT
1/4" FLAT
WASHER
1/4" NYLOCK NUT
1/4" NYLOCK NUT
1/4" x 5/8"
HEX BOLT
1/4" NYLOCK NUT
1/4" x 5/8"
HEX BOLT
CROSS
BRACE
1/4" NYLOCK NUT
1/4" x 1"
HEX BOLT
1/4" NYLOCK NUT
5/16" x 3/4"
HEX BOLT
CROSS
BRACE
DOOR
LATCH
NYLON
WASHER
5/16" NYLOCK NUT
1/4" x 3/4"
HEX BOLT
1/4" FLAT
WASHER
1/4" NYLOCK NUT
POLY HARD TOP
1/4" FLAT
WASHER
21. Screw a 1/4" nylock nut onto a 1/4" x 1" hex bolt until
it is about 1/4" from the bolt head. Insert the bolt into
theholeshowninthesideofthecartingure12.
Fasten the bolt to the cart using a 1/4" nylock nut.
Tightenso that the nut is one or two threads past the
end of the bolt. Repeat on the other side.
22. Assemble the cross brace to the top rear holes in the
side panels using four 1/4" x 5/8" hex bolts and 1/4"
nylocknuts.Seegure12.
 previous next