Filter
Top Products
12 Agilent N518xA, E8663B, E44x8C, and E82x7D Signal Generators Programming Guide
Getting Started with Remote Operation
Using the Web Browser
2. Launch the PC or workstation web browser.
3. In the web browser address field, enter the signal generator’s IP address. For example,
http://101.101.101.101 (where 101.101.101.101 is the signal generator’s IP address).
The IP (internet protocol) address can change depending on the LAN configuration (see “Using
LAN” on page 28).
4. On the computer’s keyboard, press Enter. The web browser displays the signal generator’s
homepage.
5. Click the Signal Generator Web Control menu button on the left of the page. The front panel web
page displays.
NOTE If you are experiencing problems with opening the signal generator’s remote front panel
web page, verify that the pop-up blocker is turned off on your web browser.
In some cases the Web-Enabled front panel may appear behind the main browser
window, so you must move the browser window to see the Web-Enabled front panel.
To control the signal generator, either click the front panel keys or enter SCPI commands.