Filter
Top Products
Configuration - 3
39
For now, you will only be accessing the Network Configuration and the Identification Configuration
screens.
Network Configuration
NOTE: The settings that you enter in this screen are determined by your network administrator.
In the Initial Screen, select 1 to configure your network. Select 1, 2, 3, or 4 to enter the IP address,
Subnet Mask, Default gateway, or password.
IP Address sets the IP address of the Agilent E4370A MCCD. It is in dotted decimal format.
The Subnet mask is the subnetwork that the Agilent E4370A MCCD is connected to. If it is set to 0 it is
assumed that subnetting is not performed on this network.
The Default Gateway is the IP address of the gateway for the Agilent E4370A MCCD. This allows
communication with a computer on a LAN other than the one to which the unit is connected.
MCCD Configuration Screens
1) Network Configuration
2) Identification Configurations
3) Digital I/O Configuration
4) Perform Calibration
5) Miscellaneous Configuration
Type a number and press Enter
Network Configuration
IP Address 000.000.000.000
Subnet Mask 000.000.000.000
Default Gateway 000.000.000.000
Network Password
1) To change IP Address
2) To change Subnet Mask
3) To change Default Gateway
4) To change Password
Type a number and press Enter or ctrl-G to return to initial screen