Filter
Top Products
Page 5
Clean Pump (continued)
Insert the Pump back into the Pump Tower making sure that:
• The Rubber Feet on the Pump are facing up.
• The Face Plate is facing toward you.
• The Pump Wire goes behind and underneath the Pump.
• Pump is securely seated in the tube in the Pump Tower.
• Pump Wire does not need to go into Wire Slot at this time.
• Do not put Cover Plate or Filter back in place at this time.
Run Dish Soap Through Pump
• Turn Grow Surface right side up and place it in AeroGarden Bowl
without water. (Yes, without water… just for this step!)
NOTE: If Pump falls out, it was improperly seated in the Pump Tower. Please
see Step 4D for instructions on proper placement of Pump in Pump Tower.
• Place Bowl back on Base and plug in AeroGarden. Your Pump
will start at this time (listen for a humming sound or put hand on
Grow Surface to feel vibration. If your Pump Does Not Start, see
Troubleshooting on page 7.)
• Allow Pump to run for 3 minutes and then unplug AeroGarden.
E
Rinse Dish Soap from Pump & AeroGarden
• Remove Bowl from Base.
• Remove Grow Surface from Bowl and turn Grow Surface upside down.
• Disassemble Pump Parts (see steps 1-3 on page 4).
• Thoroughly rinse all Pump Parts, Pump, Pump Tower and Bowl in sink with hot water until no soap
residue remains. Any remaining soap could harm your plants.
F
If you are cleaning your Pump due to noise, we recommend repeating “Clean Pump” steps 4A-4F for best results.
When you are nished cleaning the Pump, set the Face Plate Dial
to “2”. (If your Face Plate does not have numbers, set the Dial to
the 2 o’clock position, as shown on the black Face Plate at right.)
G
Face Plate Dial
Reassemble Pump Parts – Impeller, Impeller Cover and Face Plate.
H
IMPORTANT!
4
D