Filter
Top Products
Remove & Save AeroGarden Water & Seed Pods
Skip this step if your AeroGarden is not planted and proceed to Step 2 on page 3.
Unplug your AeroGarden.
Remove Bowl from Base.
Remove Grow Surface and place in sink (or on towel) as
roots will drip water.
Pour water from Bowl into shallow dish to a depth of 1”.
Pour remaining water from Bowl into container that
holds at least 1 gallon and set aside.
Gently remove Seed Pods from Grow Surface* and place
plants upright in shallow dish. Be sure roots are in water.
A
B
C
Page 2
D
E
F
Grow Surface (upside down)
AeroGarden Components (continued)
*Use the illustration and corresponding numbered spaces to indicate where Seed Pods are located in the
Grow Surface Openings so you can replace them in the same position later.
1.
2.
3.
4.
5.
6.
7.
Filter
Cover Plate
Pump located
behind Filter
Wire Slot
Pump Wire
Contact Strips
Pump Tower
Pump Connector
Grow Surface
Baking Dish
1 Gallon Container
Don’t worry if you tear a few roots or if the Cross Beams come out
with the roots. Cross Beams can easily be placed back in position (see
Troubleshooting for instructions).
1