Filter
Top Products
PRO
200
U.S. CAUTION
–
You are cautioned that any changes or modications not expressly approved in this manual could void your
authority to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or
relocate the receiving antenna; Increase the separation between the equipment and receiver; Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected; or, Consult the dealer or an experienced radio/TV technician for help.
To reduce the risk of electric shock, this furnishing has a
polarized plug (one blade is wider than the other). This
plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the
proper outlet. Do not change the plug in any way.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION: POUR ÉVITER UN CHOC ÉLECTRIQUE,
PRÉSENTER LA LAME LARGE À LA FENTE LARGE ET
POUSSER JUSQU’AU FOND
.
© 2007-2008 AeroGrow International, Inc., Boulder, CO U.S.A. U.S. Patents Pending
5/8/08
Prepare For Your Next Garden (continued)
If you have already grown a garden in your AeroGarden, please follow the instructions below to reset
the nutrient timer:
• Press and HOLD “Reset” button until red “Add Nutrient” light blinks (approximately 9 seconds).
• Release “Reset” button. “Add Nutrient” light will turn off.
• Your AeroGarden is now reset. (In some cases you may see other lights blink as well. This is nothing to worry about.)
Replanting Your AeroGarden
Reset
Add Nutrient
!
Bundle cord when furnishing is not in use.