Filter
Top Products
When “Replace Grow Bulbs” light on Control Panel begins blinking
after 6 months of use…
• Unplug AeroGarden PRO
200
.
• Remove old Grow Bulbs and carefully discard*.
IMPORTANT: To avoid burning, be sure Grow Bulbs are cool before handling.
• Insert new Grow Bulbs into Lamp Hood.
• Plug in AeroGarden PRO
200
and press and release “Reset” button to
restart grow bulb timer.
Early Grow Bulb Replacement
If you replace Grow Bulbs before “Replace Grow Bulbs” light illuminates, be
sure to restart grow bulb timer as follows:
• Press and hold “Lights” button until white light next to your selected plant
type starts blinking – about 5 seconds.
• Release “Lights” button. The plant type selected light will continue to blink
for about 9 seconds. While plant light is still blinking…
• Quickly press and release “Reset” button. “Replace Grow Bulbs” light will
blink once and the plant selected light will stop blinking.
Raise Lamp Hood (Lights)
As plants grow to 1-2” from lights, raise Lamp Arm one notch at a time (each of the three Lamp Arm sections has
three notches). Be sure Lamp Arm is set at the lowest setting when you start your AeroGarden PRO
200
.
Unplug AeroGarden PRO
200
and remove Bowl
from Base.
Raise Lamp Arm/Lamp Hood:
• Hold Lamp Arm where it connects to Lamp Hood with
one hand. With other hand, push in Locking Lever.
• Release Locking Lever while pulling up on Lamp Arm.
• Locking Lever will automatically click into next
notch in the Lamp Arm section.
Replace Bowl on Base and plug in
AeroGarden PRO
200
.
Push Locking
Lever in
Push Locking
Lever in
Push Locking
Lever in
Push Locking
Lever in
Basic Reminders About Your AeroGarden
(continued)
AeroGarden PRO
200
Lamp Arm & Hood Features
1
2
3
Replace Grow Bulbs – Order bulbs at www.aerogardensupport.com
12
*Check with local recycling authorities for light
bulb recycling availability in your area.