Filter
Top Products
SETUP
SETUP
32
Press and hold the “SET” button to enter into setup mode. The time will
begin blinking.
To adjust the currently selected (flashing) preference item, press the
“ ” or “ ” buttons.
To save your adjustments, press the “SET” button again to move on to
adjusting the next preference. The preference set order is as follows:
CLOCK HOUR
CLOCK MINUTE
TEMPERATURE SCALE (ºF or ºC)
You will automatically exit SET MODE if no entries are changed for 30
seconds. You may enter basic setup mode again at any time by
pressing the “SET” button.
Display Unit : Basic Setup
Battery Choice & Temperature Range
Extended periods of cold temperatures ( below -4ºF / -20ºC ) can cause
alkaline batteries to function improperly. This will cause the outdoor
sensor to stop transmitting temperature readings. Use lithium batteries in
low temperature conditions to ensure continued operation for wireless
sensors placed outdoors. NOTE: Rechargeable batteries are not
recommended due to higher operating voltages.
Install Batteries - Outdoor Sensor
Remove the battery
compartment cover.
Install 2 fresh “AA”
batteries as shown here.
BATTERIES MUST BE
INSTALLED FOR THE
SENSOR TO OPERATE
Install Batteries - Display Unit
Remove the battery
compartment cover.
Install 3 fresh “AA”
batteries as shown
here.
Wireless Signal Reception Icon
The display unit has a wireless signal reception icon near the outdoor
temperature display area. If there are a low number of “bars” present
in the icon, you may experience no temperature display ( “- -” ) or
inaccuracy. In either case, you may need to relocate one or both of the
units. If most or all 4 of the bars are present, wireless reception is good
and no action is required.
LOW HIGH
SIGNAL RECEPTION
(animated bars) (flashing tower)
SEARCHING
FOR SIGNAL
NO SIGNAL
RECEPTION