Filter
Top Products
14
Problem Possible Solution
Inaccurate
temperature or
humidity
• Make sure both the display unit and 3-in-1 sensor are
placed away from any heat sources or vents (see page 9).
• Make sure both units are positioned away from moisture
sources (see page 9).
• Make sure 3-in-1 sensor is mounted at least 5 ft off of
the ground.
• Calibrate indoor and outdoor temperature and humidity
(see page 15).
Inaccurate wind
readings
• What is wind reading being compared to? Pro weather
stations are typically mounted at 30 ft high or more. Make
sure to compare data using a sensor positioned at the
same mounting height.
• Check location of the sensor. Ensure it’s mounted a
minimum of 5 ft in the air with no obstructions around it
(within several feet).
• Ensure wind cups are spinning freely. If they hesitate or stop
try lubricating with graphite powder or spray lubricant.
Display screen
not working
• Check that the batteries are installed correctly.
Batteries may need to be replaced.
• Reset the display by pressing the RESET button, located on
the back of the display unit in the battery compartment.
Date and time will need to be entered after a reset.
Inaccurate barometric
pressure
It may take up to 14 days for the pressure to calibrate to
your location.
The unit lost power
or batteries were
changed and the
time is not correct
The Intelli-Time battery needs to be replaced
(see page 16). Once the new battery is installed,
time and date will need to be set manually.
Troubleshooting
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.AcuRite.com or call
(877) 221-1252 for assistance.