Filter
Top Products
8
INSTALLING THE SHARPENING MACHINE
Install the machine on a bench or stand.
NOTE:
The machine must be securely fixed. 1
The machine should be mounted so that the
front edge of it reaches 1-5 mm over the edge
of the bench or stand. 2
POWER SUPPLY
For optimum performance, the machine should be connected to a 12-volt car
battery, but it can also be powered from a battery charger or some another
converter with an output of 12 to max 15 volts (at least 10 amps).
Connect appropriate cables to the terminals of the sharpening machine.
Connect the red cable to + and the black to -.
If the cables are switched the grinding machine will not work.
Check that the direction of rotation agrees with the arrow on the
grinding wheel guard.
CUTTING ANGLE
The cutting angle can be varied between 90°
and 50
°. Slacken knob 18. Turn the grinding
head to the correct degree marking and
tighten the knob. Fig A.
GRINDING ANGLE
The grinding angle can be set from 0°-35°.
Loosen the knob to change. Turn the grinding
head to the desired angle on the degree scale.
Tighten the knob. Fig B.
1
2
The grinding wheel must not be running when the
sharpening machine is being set up. The incoming power
must always be switched off when during set up.
F
ig A
18
Fig B
35
35
30
30
25
25
15
15
10
10
5
0
5
The machine must not be located
close to gas, liquids or other
materials that might catch fire or
explode.