Filter
Top Products
13
GRINDING THE DEPTH GAUGE LUGS
Set the grinding angle (o° degrees); see under Grinding angle.
Install the correct grinding wheel 1 (Fig G) for grinding the depth gauge
lugs (6 mm). Profile the grinding wheel so that it matches the lugs 2.
Adjust 3 back so that the grinding wheel 1 is aimed at the lug 2. (Apart from
this, perform the adjustment in the same way as when adjusting the grinding
of cutting links).
The incoming power must
always be switched off.
Check that the grinding wheel is not cracked and
that it is securely fixed to the spindle.
Stop the grinding wheel immediately if abnormal
vibrations occur.
Fig H
3
2
1