193
Turns off the MAC filte
fo
a port(s).
Adds a MAC filter MAC entry.
Removes a MAC filter MAC entry.
Se
s the packet type filte
fo
a specific
port.
none accepts all packets. This
command disables the
pktfilter
pppoeonly <portlist>
command.
Se
sIEEE802.1
to use the local
profiles or an external RADIUS
ser
er for authentication.
Turns on IEEE 802.1
fo
specific ports.
Turns off IEEE 802.1X for
specific ports.
Sets the IEEE 802.1X port
authentication option for specific
ports.
Sets the IEEE 802.1X re-
authentication option for specific
ports.
Sets the IEEE 802.1X re-
authentication period for specific
ports.
MSAP2000 AAMS User’s Guide
Table 61 Switch Commands (continued)
COMMAND DESCRIPTION
disable
<portlist>
set <port>
<mac> [<mac>
<mac> ...]
delete <port>
<mac> [<mac>
<mac> ...
pktfilter
See Section 28.13 on page 242 for
how to configure packet filters.
show [portlist] Displays packet type filter settings.
set <portlist>
[pppoe|ip|arp|n
etbios|dhcp|eap
ol|igmp|none]
pppoeonly <portlist> Uses this command to allow only
PPPoE traffic. It drops any non-
PPPoE packets.
This command disables the
pktfilter set <portlist>
[pppoe|ip|arp|netbios|dhc
p|eapol|igmp|none]
command.
dot1x
show [portlist]
Displays IEEE 802.1X settings.
enable Turns on IEEE 802.1X.
disable Turns off IEEE 802.1X.
auth <profile|radius
>
port
enable
<portlist>
disable
<portlist>
control
<portlist>
<auto|auth|unau th>
reauth
<portlist>
<on|off>
period
<portlist>
<period>
