24
3. How can I finish my programming if the
display has already changed to time/
temperature?
During programming, if no buttons are
pressed for five minutes, the thermostat will
enter the HOLD mode and maintain a con-
stant temperature. The display will change
to the time/temperature mode. To resume
programming, press
VIEW
PRGM
until you return to
the point where you stopped programming.
Then you may continue to program the
thermostat normally. If you want to stop
programming at this point, press
RUN
PRGM
to
start the normal program function. See
PROGRAMMING YOUR THERMOSTAT.
4. What happens if the electricity goes off
or is manually shut off?
If you have not installed 3 "AA" alkaline
batteries, the display will go blank and the
program will be lost in approximately one
minute. When electricity is restored, the
clock will reset itself to 12:00 PM (noon) and
the thermostat will maintain a heating tem-
perature of 64°F and a cooling temperature
of 82°F until you reenter your program.
Setpoint temperature will not be displayed.
If fresh "AA" Energizer
®
alkaline batteries
are installed, the program will be main-
tained for about one year with no 24vAC
power present to the thermostat. See OP-
ERATING YOUR THERMOSTAT.
