SURFACE BURNER OPERATION FOR
ELECTRIC IGNITION MODELS ONLY
I. Push In and turn knob counterclockwise to the “start”
position.
2. When the burner Ilghts, turn the knob clockwise to the
desired setting.
Do not leave the knob in the maxi-
mum counterclockwise position once the burner
lights.
3. If the flame should go out during the cooking operation,
turn burner off. If gas has accumulated and a strong odor
is detected, wait five minutes for odor to disappear.
To relight burners repeat steps 1 and 2 above.
WARNING:
Due to safety considerations the followlng precautions
should be observed:
I. The top burner flame size should be adjusted so that It
does not extend beyond the edge of the cooking utensil.
2. Storage in the cabinets above the rangecanbepotentially
hazardous due to heat and to the fact that children might
climb on the range to reach cabinets.
3. Do not use the range burners or the oven for space heat-
ing.
4.
DO
not use the oven for storage space.
WIRING DIAGRAM LOCATION
Wiring diagrams are located on the back of the range and
with these instructions please examine before attempting
service work.
INSTRUCTIONS FOR
DISCONNECTING POWER SUPPLY:
I. REMOVE BURNER GRATES AND RAISE MAIN TOP.
2. THE DISCONNECT IS LOCATED BEHIND RIGHT REAR
BURNER. REACH UNDER TOP AND GRASP THE
RECTANGULAR PLUG AT THE BOTTOM OF THE WIRE
SHEATH AND PULL UP WITH A SIDE TO SIDE MOTION.
FOR INSTALLATION IN MOBILE HOME
If range
IS
installed in a mobile home the lnstallatlon must
conform with the Federal Standard for Mobile Home Con-
struction and Safety, Title 24, HUD [Part 2801 or, when
such standard IS not applicable, with local codes.
TO INSTALL:
I, Remove range leveling legs.
2. Secure to floor with screws through leveling leg holes
TO RECONVERT RANGE FROM LP TO
NAT. GAS
a. Change pressure regulator setting from LP to NAT.
(See To Convert Pressure Regulator).
b. Screw the burner orifice hoods away from the orifice
pins.
c. Remove the oven control knob and turn the select-a-
gas screw to NAT. position. This screw is located on
the oven control [thermostatl. The mid position turns
the oven pilot off.
d. Top burner pilots (for models with pilot lgnltlon only1
adjust top burner pilot to approximately %-Inch
high. This adjustment is on the oven control on some
models and on the manifold pipe on some models.
e. UPPER OVEN PILOT ADJUSTMENT: Turn Select-a-
gas adjuster screw as outlined for the lower oven
pIlot.
f. Adjust the burner air shutters to the widest opening
that will not cause the flame to lift or blow off of the
burner.
TYPICAL INSTALLATION
irAY BE INSTALLED WITH ZERO CLEARANCE SIDES AND BACK
MAXIMUM DEPTH OF OVERHEAD CABINET8 IS 13’
* TMLIE OIYCNSIONS ARE MT PROPORTIORAL TO DRAWINO
