Caring For Your Dryer
Contlnued
Lint removal
Lint can gather inside the dryer and be
a fuel for fire, It is recommended the
lint be removed every 2 to 3 years, or
more often, depending on dryer
usage. Cleaning should be done by a
qualified person. lf you have any
questions, please call our Consumer
Assistance Center at 1-800-253-l 301.
Ebotrk dya with back panel ranoved
lanker 1
Gas dryer with bwer front
10
access panel removed
ElectrIcal Shodc and
Personal Injury Hazard
l Unplug the power supply cord
or turn off the elect&al power
before removing dryer panels.
l Make sure the dryer Is cool.
l Dryer parta can have sharp
edgea Use care when han-
dllng.
l When replacing front panel
after lint removal, the wlre cllps
holding the door awftch wlree
must be anchored to top of
front and skle panels. Wires
MUST NOT touch rotating
drum. (See page 11, step 7.)
Failure to do eo could result in
elect&al shock or personal
Injury.
f your dryer Is electrk, or la gas
and has a lower front access panel:
1. Unplug the power supply cord or .
turn off the elecirical power.
2 Remove back panel (electric) dr
bwer front access panel (gas). See
Installation Instructions.
3. Remove lint from shaded area in
illustration with a soft brush or
vacuum deaner. Avoid damaging
wires, thermostats (electric), funnel
(gas) or igniter (gas).
4. Replace panel; reconnect and
level dryer again, if necessary.
NOTE: See page 11 if your dver is
gas and has a full front panel.
