Installing Your Freezer
Proper installation of any appliance is very important. This section will tell you,everything you
need to know to install your freezer properly.
Installing the handle
1.
2.
3.
4.
Remove screws from front of freezer door
and discard.
Locate handle assembly kit among
packing materials.
Attach top of handle to top hole in door
with shorter of 2 screws provided.
Attach bottom of handle to lower hole in
door with longer of 2 screws.
II
Handle II
Freezer
door -
I’
nG-f&
Trim piece
Use longest
screw here
5. Snap trim piece into place.
Cleaning your freezer
Clean your freezer thoroughly before using it.
1. Use a sponge, cloth, or paper towel and
mild detergent in warm water to clean
outside and inside of freezer, door liner,
and gasket.
2. Rinse and dry thoroughly.
Locating the proper electrical supply
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electrical
supply is required. It is recommended that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.
Attach power cord lock, from literature
package inside the freezer, over power cord
plug. See Electrical Requirements and
Grounding Instructions Sheet in literature
package for complete details.
6
