70
• See “Setting the End Code Operation (Motorola
Systems Only)” on Page 85
• See “Setting I-Call (Motorola and EDACS Sys-
tems Only)” on Page 85
• See “Setting Emergency Alert (Motorola and
EDACS Systems Only)” on Page 86
• See “Setting Control-Channel Only (Motorola Sys-
tems Only)” on Page 86
• See “Setting System Lockout” on Page 81
• See “Reviewing Locked Out Frequencies” on
Page 111
• See “Setting System Attenuation (Trunked Sys-
tems Only)” on Page 88
• See “Deleting Systems” on Page 88
• See “Copying Systems” on Page 89
• See “Setting System Frequencies” on Page 70
• See “Entering/Editing Motorola Channel Groups”
on Page 72
Setting System Frequencies
Program System
Select the system
Set Frequencies
Input a system frequency, then press the scroll control.
To enter additional frequencies, press , use the
scroll control to select New Frequency, then repeat
the above.
Note: If you select Control Channel Only mode (see
“Setting Control-Channel Only (Motorola Systems
Only)” on Page 86), you only need to enter the
frequency(s) that can be assigned as the control
channel. Most frequency lists usually indicate which of
the frequencies are the control channel frequencies.
Otherwise, you must enter all of the frequencies.
Menu
Menu
