9
SCANNING
When rst used, your radio scanned the DAB band for
available stations. The station services found were then
stored in your radio’s memory.
You can re-scan the band at any time if you move to a dierent
area or just to refresh the stored list of available stations.
Two types of scan are available, a Local Scan that scans UK
DAB bands for available services and a Full Scan, that scans
all bands.
TO START A SCAN
Switch on the radio and select the DAB band.•
Press the • MENU button briey.
‘Manual tune’ is displayed.
Press the • button once.
‘Autoscan’ is displayed.
Press the • SELECT button to start the scan.
The scanning display will be shown while the scan takes place.
SLEEP MODE
The Sleep function allows you to program your radio to
switch itself o after a set period of 90, 80, 70, 60, 30 or 10
minutes.
To activate the Sleep function:
Press the • SLEEP button.
The display will show Sleep Timer 90 minutes.
Now press the • SLEEP button repeatedly until your
required sleep time appears on the display.
After a few seconds the Sleep display will disappear and the
letter ‘s’ will appear on the display as shown below to conrm
that sleep mode is activated..
MANUAL TUNING
If preferred, you can also tune DAB stations manually.
To Manually tune:
Press the • MENU button briey.
The radio will now display the legend ‘Manual tune’.
Press the • SELECT button to select manual tuning.
Press the • or button repeatedly to browse the DAB
multiplex channels.
Press the • SELECT button to select the channel
displayed.
The number and frequency of the selected multiplex will be
displayed. If a station multiplex is located on this channel the
multiplex name will scroll across the display. The bottom line
of the display will show a signal strength bargraph that can be
used to adjust the aerial for maximum signal strength.
You can now press the • or button to change to
another multiplex channel or the SELECT button to
exit manual tuning and play a station from the selected
multiplex.
Your radio will continue to play, then will set to Standby
when the sleep time expires.
To cancel the Sleep function once set:
Press the • SLEEP button during Sleep mode.
The sleep symbol letter ‘s’ will disappear from the display.
Sleep mode set
Number of stations found
Progress bargraph
A bargraph shows scan progress and the number of services
found is displayed.
