A SERVICE OF

logo

Problem
Possible cause
Solulion
Theextr¡¡clorf¡¡nooesnotworl<.
ThemamscablelsnotconneCtedtothe
Connect mains catite to the networl<.
network
Thereisoo currenlin the r.etworl<.
Providecurrenttother.etwork
Thekltchenhooddoesnotextract
Flltersaresaturatedwithfa!
ChangeordeantheadJvecnarcoaland/ormeta!
suff'oenllyorVlbrales
fliters,asthecasemaybe
Obstroctionin!heaireKitconduct
Removetheobstroction
Thelampsdonotllghlup
The\amps are bloW1"l
Changelhelamps
Thelampsareslack
Tigh!enlhelamps
~lmanual_dbr_2501.qXP 19/02/2008 12:52 Página
~
~I
Cleaning and ~intenance
---1
During cleaning
and maintenance work,
make sura
the safety ¡nstruetions set out
on page 10 are eomplied wilh.
The metal fillers can be cleaned by soaking
them
in hat water with
neutral detergent until
the fat dissolves
and then
rinsing them under
the tap or using special
antj.grease products.
They can also be washed in a dishwasher. In
this
case, it is advisable to stack them
vertically lo avoid food residues lO slick to
Ihem.
Cleaning in a dishwasher may damage Ihe
metallic surtace (blackening il). allhough this
will not affeet
its fat retention capacity.
Once clean. leave them to dry off and then tit
Ihem onlo Ihe kilchen hood.
Cleaning Ihe hoo.!!.body
":J
If your kitchen
hood
is mada from
stainJess
steel, use proprietary cleaners mentioned
in the product
instructions.
It your kilchen hood is painled, use
lukewarm
water
and a neutral soap.
Never use metallic scourers,
nor abrasive
or corrosiva
products.
Dry Ihe kilchen hood using a clolh that
does not produce
fibres.
The use of vapour
cleaners is not
recommended.
Cleaning Ihe melal fillers __
To remove the
filters from their fjttings, press
lightly on the locks and then pull them off.
__ -:Changing lighl tm"lb"T'
Proceed as follows:
Remove the melal filters.
Change Ihe broken/burnl out lamp.
Maximum lamp power is 40W (E-14).
Fil the metal filters.
- Problem,solviñ¡j- - ---=-
-=--
Proceed wilh Ihe following checks before calling Ihe Technieal Service:
Size!!!!ñasp~ficatiOñs - _ - _
....
See page 34.
TEKA INDUSTRIAL S.A. reserves Ihe righl to make changes and correclions lo ils producIs as
it
deems necessary, without altering their basic
characteristics.
12
-$-
L
.
...
.,
+
I