A SERVICE OF

logo

Open as PDF
next previous
The manufacturer reserves the right to make changes and corrections to its products as it deems
necessary, without altering their basic characteristics.
• Ifyourkitchenhoodismadeofstainlesssteel,
use proprietary cleaners mentioned in the
product instructions.
• Ifyourkitchen hoodispainted,uselukewarm
water and a neutral soap.
• Never use metallic scourers, nor abrasive or
corrosive products.
• Drythekitchenhoodusingacloththatdoesnot
produce fibres.
• Donotusevapourcleaners.
• Toremovethe filters fromtheir fittings, press
lightly on the locks and then pull them off.
• The metal filters can be cleaned by soaking
them in hot water with neutral detergent until the
fat dissolves and then rinsing them under the tap
or using special anti-grease products. They can
also be washed in a dishwasher. In this case,
it is advisable to stack them vertically to avoid
food residues to stick to them.
• Cleaning in a dishwasher may damage the
metallicsurface(blackeningit),althoughthiswill
not affect its fat retention capacity.
• Onceclean,leavethemtodryoffandthenfit
them onto the kitchen hood.
Problem solving
Proceed with the following checks before calling the Technical Service:
Active charcoal filters (Optional)
When exterior gas extraction is not possible, then the kitchen hood may be set to purify the air by recycling
it through active charcoal filters.
The active charcoal filters have an active life of between three to six months, depending on the individual
conditions of use. These filters cannot be washed nor regenerated. They must be replaced once their useful
life comes to an end.
GB
Problem Possible cause
Solution
The kitchen hood does not
work.
The mains cable is not
connected to the network.
There is no current in the
network.
Connect the mains cable to the
network.
Provide current to the network.
The kitchen hood does
not extract sufficiently or
vibrates.
Filters are saturated with fat.
Obstruction in the air outlet.
Change or clean the active
charcoal and/or metal filters.
Remove the obstruction.
The lamps do not light up.
The lamps are blown
The lamps are slack.
Change the lamps.
Tighten the lamps.
Cleaning the hood body
Cleaning and maintenance
Cleaning the metal filters
Lamps
During cleaning and maintenance work, make
sure the safety instructions are complied with.
• Lampsincludedinthisproductaredesigned
exclusively for the illumination of the cooking
area.
• Theselampsarenotaptforlightingdomestic
areas