BIL-JAX 3522A
MATERIAL LIFTING HOOK
If the boom lift is equipped with a material lifting
hook, observe the following procedure for material
lift operation:
Remove platform controls from the work
platform by releasing the latch on the back of the
platform control box.
Disconnect platform control box from the load
sense module located on the boom lift bulkhead.
Remove the electric loopback plug from the
receptacle on the bottom right of the ground
control panel (Figure 8-1) and insert the platform
control cable into the open receptacle.
46
Figure 8-1. Material Lifting Hook Configuration
Insert the removed electric loopback plug into
the open receptacle on the load sense module,
replacing the platform control cable.
Remove the retaining pin holding the platform to
boom lift. Firmly secure platform to prevent
equipment damage.
Remove the platform from the boom by lifting
cage up and away from the mounting bracket on
the boom nose.
Attach the material lifting hook to the mounting
bracket on the boom nose and insert the
retaining pin (Figure 8-2).
Figure 8-2. Material Lifting Hook Installation
Operate the material lifting hook remotely, using
the platform control box for optimal control.
WARNING
Always observe the manufacturer’s weight lifting
limitations when using the material lifting hook.
Always use lifting straps or wire rope slings that
are rated at a minimum 500 lbs lifting capacity.
Failure to observe all weight limitations and
rated capacities may cause boom lift or materials
to fall. Falling objects can cause serious injury
or death.
Reverse the procedure to reattach the work
platform.
