– 6 –
SPECIFICATIONS AND OPERATION
Buzzer beeps 1 time.
Press both
switches.
Start
Buzzer beeps twice.
Buzzer beeps 3 times.
Buzzer beeps 4 times.
Buzzer beeps 5 times.
Release within 2 seconds.
Enters "Adjust Paper-Out Sensor" mode.
Release within 2 seconds.
Enters "Adjust Paper-Near-End Sensor"
mode.
Continue to
hold down.
Both switches
Release within 2 seconds.
Enters "Set Head Rank" mode.
Continue to
hold down.
Both switches
Release within 2 seconds.
Resets, then executes test print.
Continue to
hold down.
Both switches.
Release within 2 seconds.
Enters "Set Memory Switches" mode.
Continue to
hold down.
Both switches
Continue to
hold down.
4. Using the control panel to adjust the sensors, select the head rank, and set the
memory switches.
Hold down the FEED and ONLINE switches while setting power on, then continue to hold the switches down for the time
necessary to enter the required mode, as indicated below.
