User instructions
15
TO CHANGE A PROGRAM
To change the running program it is necessary:
• to interrupt the running program (see “
I
NTERRUPTION OF A PROGRAM
”);
• select the new program;
• to press again the
START/PAUSE
button
(4)
to make start the new program.
ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see “
I
NTERRUPTION OF A PROGRAM
”).
Now press buttons
P1
+
P2
simultaneously and the first three program
lights will come on.
In case that the door is opened during the operation, to the next door closing it is going to be
necessary to start the program as shown in paragraph “
S
TART PROGRAM
”. The program will resume
from the point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program will start about 30 seconds
later.
1.2 Washing programs
The dishwasher is equipped with a control panel, described in chapter "1. Description of the
controls", from which it is possible to carry out all the power switch-on, switch-off and programming
operations.
Before starting a washing program make sure that:
•
The water supply tap is
open.
•
The
correct amount of detergent
has been added to the
dispenser
.
•
The baskets have been
correctly loaded.
•
The spray arms are able to
rotate freely
and without obstruction.
•
The dishwasher door is
securely closed
.
DELAY PROGRAM
(on some models only)
Pressing button
DELAY PROGRAM (3)
in sequence delays the start of the program by
3
,
6
or
9
hours
. This allows you to set the dishwasher to work at specific times of day.
After selecting the delay, start the program in the normal way (see relative section).
The appliance will prewash the dishes, after which the “delay program” set previously will come into
effect (the light corresponding to 3, 6 or 9 hours flashes).
To
reset or change the delay
once the program has started:
• press the
START/PAUSE
button
(4)
for a few seconds, until the
PROGRAM PHASES
lights
(8)
come on;
• press the
DELAY PROGRAM
button
(3)
several times “until the program delay” returns to zero
(all the lights indicating the delay go out);
• press the
START/PAUSE
button
(4)
to start the new program.
