A SERVICE OF

logo

USBCam2 User Guide B1051061 Rev. –
11
3.4. Setup with Windows 2000
PLEASE NOTE: Do not connect USBCam2 until you have completed the following steps.
If prompted, install DirectX 9 and restart your computer at the end of installation.
STEP 1
A. Insert the “USBCam2 Driver” CD.
Setup should start automatically. If it
doesn't, click Start, Run, and then enter
d:\setup at the command line (if your
CD drive is a letter other than "d", use
that letter instead).
B. Click Next to begin the setup process.
STEP 2
A. Choose Complete. This is the
recommended installation and is
appropriate for most customers.
B. Click Next.
STEP 3
Click Install.